C.Scope 80m Flexible Pipe Tracer

Safety Gear Store is pleased to offer the C.Scope 80m Flexible Pipe Tracer.

The C.Scope 80m Pipe Tracer is a flexible cable which has been designed for line and end tracing on thin, non-metallic ducts, pipes, sewers and drains. It allows pre-excavation inspections in addition to finding blockages or obstacles within the pipe itself. The 5mm diameter is suitable even for the thinnest pipes and the 10cm bend radius means it can be used on intricate systems.

The integral copper wires in the C.Scope YIRRFT80 are optimised for transmitting a 33kHz signal as supplied by a C.Scope Signal Generator/Transmitter. The tracer can be energised along its entire length for line tracing or solely at the end where a tiny integrated sonde can emit a stronger signal that penetrates up to 4m. This can be used for finding obstructions in plastic pipes and also permits depth measurement with suitable locators.

The C.Scope YIRRFT80 has a solid steel frame which turns on its axel to unravel the tracing rod as well as a slip ring on the axel which allows the Signal Generator to stay attached to the tracer whilst it is being fed into an underground conduit. The tracer rod and tip have sturdy fibreglass cladding with an IP rating of 68.

• Tracing rod length: 80m
• Optimised signal frequency: 33kHz
• Signal penetration: 4m at tip, 3m along line
• Rod diameter: 5mm
• Tip sonde diameter: 7.5mm
• Min. rod bend radius: 10m
• Slip ring keeps generator attached to tracer
• IP68-rated fibreglass cladding
• Integrated sonde at tip

Frequency: Optimised for 32,768Hz

Detection Depth Range: Line Detection - 3 m (10 foot) dependent upon Locator and Signal Generator type and site conditions; Tip Detection - 4 m (13 foot) dependent upon Locator and Signal Generator type and site conditions

Compatibility: Any Signal Generator or Transmitter with 33kHz or 33/131kHz combined output

Rod Length: 80m (260’)

Rod Diameter: 5mm nominal (0.2”)

Rod Material: Quality sleeved fibreglass rod with three integral copper wires

Rod Minimum Bend Radius: 10 cm (3.9”) reducing to 15 cm (5.9”), 5 cm (1.9”) from Tip

Rod Wire Diameter: 0.45mm each wire (0.018”)

Transmitting Sonde Diameter: 1.5mm max (0.3”)

Rigid Tip Length: 20mm max. (0.8”)

Tip Material: Brass

Frame Size: 58.8 x 28.8 x 48.5 cm (1’11” x 11.3” x 1’7”)
Frame Material: Powder coated 16 mm steel tube (0.6”)
Reel Diameter: 48cm (1’7”)
Weight: 1.5kg (16lb 8.5oz)
Slip ring assembly: Sealed multi-wire duplexed
Operational temperature range: -20˚C to 50˚C (-4˚F to 122˚F)
Storage temperature range: -20˚C to 50˚C (-4˚F to 122˚F)
Tracer rod and tip IP rating: 68
Casing IP rating: 54
IP rating for Terminal Box: 66